US Numeric Size
Waist
US Denim Size
Hip
Chest

Ford Ranger Wildtrak Next Gen 22-24 Gloss Black Slimline Flares with 30mm Poke (with sensor provisions)
Our Baja Parts Gloss Black Slimline Ford Ranger Next Gen flares are a perfect addition to your Next Gen Wildtrak with factory wheels, or with slightly bigger wheels (up to +15). Our flawless Gloss Black finish is a perfect addition to a Gloss Black Raptor Grill.
These flares keep the car looking factory with a subtle look, while widening your cars width. These Flares come with sensor mounts so you can securely mount your bumper sensors without causing any sensor malfunctions. They come painted in a high Gloss black finish.
Please note: Factory Ford Ranger Next Gen offset is +55
If you live in Melbourne, we offer installation services for all our products and welcome local pick up.
Please reach out to us for more information or advice on what set up you may need.
Suitable for:
– Ford Ranger Next Gen 2022-2024. Fits the following models: Wildtrak and Wildtrak X. The Next Gen Rangers have different bumpers and each flare kit we sell is specific to the front bumper of your car. If you have a model different to the Wildtrak, please check our other listings to ensure a proper fitment.
– Please note: Any Wildtrak built from 11/24 onwards does NOT have a sensor on the flare. These have been removed and we sell a gloss black kit that suits the 11/24 onwards Wildtrak Rangers.
Package contains:
– 4 x 40mm flares (Front and Back)
– 2 x Bumper Flare pieces
– 2 x Sensor brackets
– 20 x piece screw/ washer/ U- Nut
DIY skill level:
– Moderate-Difficult. Allow 2-3 hours and if in doubt, professional installation is recommended.
– We recommend for Next Gen Ford Ranger flares to follow the below procedure
1. Remove Front Standard Flares, but leave the Rear Flares on your vehicle
2. Remove all factory scrivets, replace hole with U-Nut
3. Loosely mount the flares on and loosely tighten the Screws to allow for movement and adjustment
4. Peel the edge of the Double Sided Tape so when you have found your desired position, you can remove after
5. heat the double sided tape to allow for better adhesion and fitment. Use a heat gun or a hairdryer. Note: Do not overheat the tape or you may melt the flare!
6. Peel the tape, then tighten the screws.
Please do NOT wash the car or drive in the rain for 24 hours to allow a proper finish.
| make | |
|---|---|
| model | |
| year |
Reviews
There are no reviews yet