US Numeric Size
Waist
US Denim Size
Hip
Chest
Ford Ranger Wildtrak Next Gen 11/2024- Gloss Black Slimline Flares with 30mm Poke (NO SENSOR TYPE)
Our Baja Parts Gloss Black Slimline Ford Ranger Next Gen flares are a perfect addition to your Next Gen Wildtrak with factory wheels, or with slightly bigger wheels (up to +15). Our flawless Gloss Black finish is a perfect addition to a Gloss Black Raptor Grill.
These flares keep the car looking factory with a subtle look, while widening your cars width. This Kit is designed for the 11/2024 onwards Wildtrak that does NOT feature a parking assist sensor on the bumper. This was removed from all Ford Ranger Wildtraks built from 11/2024. If you have a Wildtrak with Parking Assist sensors, we have this product with sensor provisions (see other ads). If you need more assistance to ensure you receive the right flares, please contact us.
Please note: Factory Ford Ranger Next Gen offset is +55
If you live in Melbourne, we offer installation services for all our products and welcome local pick up.
Please reach out to us for more information or advice on what set up you may need.
Suitable for:
– Ford Ranger Next Gen 2022-2024. Fits the following models: Wildtrak and Wildtrak X. The Next Gen Rangers have different bumpers and each flare kit we sell is specific to the front bumper of your car. If you have a model different to the Wildtrak, please check our other listings to ensure a proper fitment.
Package contains:
– 4 x 40mm flares (Front and Back)
– 2 x Bumper Flare pieces
– 20 x piece screw/ washer/ U- Nut
DIY skill level:
– Moderate-Difficult. Allow 2-3 hours and if in doubt, professional installation is recommended.
– We recommend for Next Gen Ford Ranger flares to follow the below procedure
1. Remove Front Standard Flares, but leave the Rear Flares on your vehicle
2. Remove all factory scrivets, replace hole with U-Nut
3. Loosely mount the flares on and loosely tighten the Screws to allow for movement and adjustment
4. Peel the edge of the Double Sided Tape so when you have found your desired position, you can remove after
5. heat the double sided tape to allow for better adhesion and fitment. Use a heat gun or a hairdryer. Note: Do not overheat the tape or you may melt the flare!
6. Peel the tape, then tighten the screws.
Please do NOT wash the car or drive in the rain for 24 hours to allow a proper finish.
make | |
---|---|
model | |
year |
Reviews
There are no reviews yet